RHINO RAMV2 Manuel d'instructions télécharger pdf (Page 24)

3.1.2. Learn a new Remote Control with Remote

To add a new transmitter to your alarm, simply follow the procedure below:

A. Turn the vehicle’s ignition on.

B. Immediately press and hold the Bottom button on the Original remote control

until the siren starts to beep (approximately 4 seconds) and then release the button.

C. Immediately press and hold the same (Bottom) button on the New remote control

for at least 4 seconds.

D. Turn the vehicle’s ignition off.

E. The new remote control is now programmed into the alarm.

F. Test to see if that remote works with the alarm

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Pas de commentaire

RHINO RAMV2 Manuel d'instructions Page 24