RHINO RAMV2 Manuel d'instructions télécharger pdf (Page 23)

3. Programming & Setup

3.1. Learning New Remotes

3.1.1. Learn a new Remote Control By SMS

SMS - To add remotes if all remotes are lost a combination of SMS and beeps can add a new

remote.

A. Send the command “LEARN”

You will receive a SMS saying:

If you receive a SMS saying

“Unable to activate learn mode Ignition on” or

“Unable to activate learn mode System Armed”

Disarm the alarm and turn the ignition to the off position and repeat step ‘A’ again.

B. Within 15 seconds the alarm will begin to beep and flash the blinkers.

C. Press and hold down the Bottom button on a remote when the beeps begin keep holding until

the beeps stop.

D. The new remote control is now programmed into the alarm.

E. Test that the remote now works.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Pas de commentaire

RHINO RAMV2 Manuel d'instructions Page 23