RHINO RAMV2 Manuel d'instructions télécharger pdf (Page 22)

2.8.15. PAT

– Past Alarm Trigger Memory/History

REMOTE CONTROL

To identify the cause of the last TEN reasons why the alarm has triggered, you can

follow the steps described in Section 3.3.3. Changing Register 3 – Page: 28. Or type

your PIN number and HISTORY from a mobile phone, and send it to the alarm. Once

the message is sent the alarm you will receive an SMS back saying

ALARM HISTORY:

Oldest XXX. XXX. XXX. XXX. … Latest

(where XXX is the cause of the alarm being triggered)

2.8.16. SMS Controlled Relay Output

The RAM incorporates 3 onboard SMS controlled relay output that can be switched on

and off with a simple message.

ONOUT1/OFFOUT1: Type your PIN number and ONOUT1 from a mobile phone,

and send it to the alarm to activate the relay output. Once the message is sent the alarm

will respond with “Output1 turned on.” To turn the relay output off send OFFOUT1

and the alarm will respond the with “Output1 turned off.”

To activate outputs two and three simply substitute the number accordingly i.e.

onout2, offout2, onout3 and offout3. There is also a command “test” i.e. 000000test

which turns on all three outputs and returns the status of the alarm.

123456OFFOUT1

123456ONOUT1

123456OFFOUT1

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Pas de commentaire

RHINO RAMV2 Manuel d'instructions Page 22