RHINO RAMV2 Manuel d'instructions télécharger pdf (Page 15)

2.6. Accessibility Note

To prevent unauthorised access to the alarm, the user is required to ALWAYS put the 6

Digit PIN (consisting of 0-9, A-Z) (the Default Pin Number is – 000000) at the start of

each SMS command to confirm the user has access to change the alarm condition (this

is nothing to do with the SIM card PIN number) i.e. Arm, Disarm, Activating relays etc.

If the PIN number is forgotten, please refer to section 3.4.4. To Change Your Pin

Number – Page: 30.

2.7. Alarm Messages

NOTE:

WHEN WRITING A SMS MESSAGE TO GO TO THE ALARM NO SPACES

ARE TO BE USED IN COMMANDS

i.e. 000000COMMAND.

When your alarm is triggered / activated, a SMS Message will be sent to all the phone

numbers programmed into the system, advising of the alarm and its trigger

i.e. Alarm Activated. Door. Ignition.

WHEN YOUR ALARM IS TRIGGERED OTHER REPLY’S MAY INCLUDE:

 PANIC ALERT!

 Battery Low Warning.

 Alarm Activated. Door.

 Alarm Activated. Bonnet.

 Alarm Activated. Ignition.

 Alarm Activated. Shock

 Alarm Activated. Auxiliary.

 Alarm Activated. Glass.

Also note that when a message is sent from your RAM, it has a customisable

identification that is displayed at the start of each message. Refer to Section 3.4.5 To

Change The ID Of The SMS message – Page: 31.

If any alarm event occurs and there is no response from either SMS or remote controls

for 1 minute the system will call the number programmed into Memory Location 1 when

enabled (Please refer to Changing Register 3 Feature 1). If there is still no response there

will be no further action taken via SMS.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Pas de commentaire

RHINO RAMV2 Manuel d'instructions Page 15