RHINO 1540 Manuel de l'opérateur télécharger pdf (Page 29)

ASSEMBLY

1540 02/12 Assembly Section 3-5

ASSEMBLY

Hydraulic Control Valve (Extra Equipment)

A 3 Spool 4 way Hydraulic Control Valve, open center or closed center, is available as Accessory Equipment.

This allows you to operate 4 Hydraulic Cylinders from two remote outlets. Connect the 3 Spool Valve to one

outlet to operate three Cylinders. Use the other remote outlet to operate the fourth Cylinder.

If Closed Center Valve is used, do not use the adjustable Relief Assembly. Use the No-Relief

Assembly.

Selector Valve (Extra Equipment)

If the Mainframe Swing, Moldboard Pivot and Tilt

are fully hydraulic, as an added feature, all three

Cylinders can be operated from two remote outlets.

Below is a schematic diagram showing proper

routing of two Cylinders through the Selector Valve.

When installing this Valve, observe all safety

precautions as hydraulic lines are under high

pressure (2500 PSI). If additional information is

required concerning your hydraulic system, contact

your Rhino dealer.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 59 60

Pas de commentaire

RHINO 1540 Manuel de l'opérateur Page 29